Provide a 10 pages analysis while answering the following question: Engine Strip and Build. Prepare this assignment according to the guidelines found in the APA Style Guide. An abstract is required.

Provide a 10 pages analysis while answering the following question: Engine Strip and Build. Prepare this assignment according to the guidelines found in the APA Style Guide. An abstract is required. The tank eased up and the rubber was also removed. Finally, bolts and nuts were replaced on the tank fittings. The tools that were used are a 10mm spanner, extension and 10mm socketAir cleaner and housing were removed by loosening the wing nuts. Then throttle handle was removed by loosening 2 *M6 nuts holding the lever and, 2 bolts on the linkages were also removed. The spring that withdraws the lever was also removed. The breather was then disconnected.The carburetor was removed from the studs, rods and a small spring was also removed. The position of the governor was also marked. Gaskets and Plastic spacer were removed at the same time noting their orientation and position. Bolts and nuts were replaced. The tools that were used for this procedure were. 10mm socket, ratchet, extension and 10mm spanner4pieces of M6 bolts were and the cover was lifted carefully to ensure that the gasket is not damaged. The plug head was pulled off and the spark plug using a spark plug socket and unscrewed using hand. The tools that were used in this procedure were sparkplug socket, (21mm), 10mm socket and 10 mm Ratchet extension4 pieces of M8 bolts are removed whereby 2 are located at the rocker box, the procedure of undoing the bolts was done in a diagonal manner. The cylinder head and gasket were removed carefully, watching the push roads and dowels. Finally, the bucket shim on the exhaust valve was removed and parts set aside carefully. The following tools were used Extension socket and Tommy barThe material that is used to make the alternator bracket is an alloy of cast iron. Cast iron is preferred because of its strength, cost, and ease of casting it. Alternator bracket should be made of very strong materials because its carrying an alternator that is connected to the engine pulley by a high tension v-belts, the bracket is also subjected to vibration because when the belt is in use, its elastic properties cause the bracket to vibrate.&nbsp.